Rowenta FITSPA TS6510 Notice D'emploi page 10

NOT 037189 TS6510+5510
- Do not unplug by pulling on the cord, rather pull out by the plug.
- Do not use an electrical extension lead.
- Do not clean with abrasive or corrosive products.
- Do not use at temperatures below 0°C and above 35°C.
GUARANTEE
Your appliance has been designed for household use only. It can not be used for commercial use.
The guarantee becomes void and is invalid for uses other than those indicated in the instructions.
2- OPERATING INSTRUCTIONS
If you suffer from a specific ailment or if you are pregnant, consult your doctor before using
FITSPA®.
1. Make sure that the setting switch (8) is in setting (1).
2. Check that the appliance is not plugged to the power outlet before filling it up with water. Place
FITSPA® on the floor, fill it with lukewarm water (or cold for a refreshing massage) staying below the
indicated mark (4) and plug it.
3. Sit on a chair and then put your feet in the appliance tank.
4. Choose the desired setting:
- Setting 1: Reflexology / digipression / exfoliation
- Setting 2: Vibrations massage + reflexology / digipression (varies according to the model) / exfoliation +
heating water
- Setting 3: Bubble bath (do not select without water) + heating water + reflexology / digipression (varies
according to the model) / exfoliation
- Setting 4: Vibrations massage + Bubble bath (do not select without water) + heating water + reflexology /
digipression (varies according to the model) / exfoliation
5. Reflexology / Digipression (varies according to the model)
- Place the reflexology (5) or digipression (6) attachment (varies according to the model) in its insert.
- Check that the central foot rest (8) is closed.
- Place the heel on the central foot rest (8)
- Put the sole of the foot on the attachment (5)/(6)
• Reflexology: Press the foot on the attachment. The 4 balls automatically rotate!
• Digipression (varies according to the model) Press the foot on the attachment.
The attachment automatically rotates!
Note: Your attachment will alternate its rotating direction in order to increase the efficiency
of the massage.
- You can also put the tip of your foot on the cover of the foot rest (9) and press your foot on the
reflexology (5) or digipression (6) attachment (varies according to the model) with the heel:
this will you will activate a complete massage of the foot.
6. Exfoliation
- Place the exfoliating attachment (7)
- Check that the central foot rest (8) is closed.
- Place the heel on the central foot rest (8)
- Press your foot: the attachment automatically rotates!
Note: Your attachment will alternate its rotating direction in order to increase the efficiency
of the exfoliation.
- You can also put the tip of your foot on the cover of the foot rest (9) and press your foot on the
reflexology (7) attachment with the heel: this way you will receive a complete exfoliation of the foot.
7. After use, switch the appliance to setting 1 and unplug it.
Digipressure
TS6510
8/02/06 14:12 Page 10
Reflexology
TS5510/6510
The use of essential
oils in your fitspa
is possible. Consult
the Maintenance
section to clean
your appliance.
Exfoliation
TS5510/6510
GB