Publicité
Les langues disponibles
Les langues disponibles
5
Preliminary preparation
5.1.What to do for
energy saving
Connecting
to
electronic
A
systems is harmful, as it may
damage the product.
• For a freestanding appliance; 'this
refrigerating appliance is not intended
to be used as a built-in appliance.
• Do not keep the refrigerator doors open
for long periods.
• Do not place hot food or beverages into
the refrigerator.
• Do not overfill the refrigerator; blocking
the internal air flow will reduce cooling
capacity.
• In order to load the maximum quantity
of food into the cooler compartment
of your refrigerator, the upper drawers
should be taken out and the food
should be placed onto the wire/glass
shelves. Net volume and energy
consumption information declared in
the energy label of your refrigerator
was tested by taking out the upper
drawers in the cooler department
and the ice bucket, which is easily
removable by hand.
• Food packages should not be in direct
contact with the heat sensor located
in the cooler compartment. The food
should be 10 cm away from the sensor.
In case of contact with the sensor,
energy consumption of the device may
increase.
the
product
energy-saving
5.2.First Use
sure the necessary preparations are
made in line with the instructions in
"Safety and environment instructions"
and "Installation" sections.
• Keep the product running without
• The temperature change caused by
14 / 36 EN
10 cm
Before using your refrigerator, make
placing any food inside for 6 hours and
do not open the door, unless absolutely
necessary.
opening and closing of the door while
using the product may normally lead to
frost deposit, icing and condensation
on food placed on door/body shelves
and glass containers placed in the
product.
A sound will be heard when
C
the compressor is engaged.
It is normal to hear sound
even when the compressor is
inactive, due to the compressed
liquids and gasses in the cooling
system.
Refrigerator/User Manual
Publicité
