Publicité
Les langues disponibles
Les langues disponibles
DC68-03768A-10_IB_WV9900M_EN.indd 29
5. Connect the other ends of the water
hoses to the corresponding inlets on the
rear of the machine as specified. Make
sure the hot water hose is connected to
the hot inlet, and the cold water hose to
the cold inlet.
6. Repeat step 2 above on the other
fittings. Make sure both water hoses
are connected properly. See the '4C'
information code for troubleshooting.
7. Open both taps, and then check if there
is a leak.
CAUTION
To prevent water hoses from being bent or
kinked, make sure there is at least a 6-inch
(150 mm) space between the washer and
the rear wall.
NOTE
If you do not want to use hot water, insert
the inlet cap into the hot water inlet. You
must purchase the inlet cap.
If the hot water inlet is closed with
the inlet cap, you must select Cold for
the water temperature. All other water
indicators turn off.
English 29
2023-06-27
7:18:38
Publicité
