Publicité
Les langues disponibles
Les langues disponibles
Tools required for installation (not supplied)
Measuring tape
Installation requirements
Electrical supply and grounding
• AC 120 V / 60 Hz / 15 AMP fuse or
circuit breaker is required.
• Use an individual branch circuit.
Connect only the washer to the circuit.
WARNING
• Do NOT use an extension cord.
• Use only the power cord that comes
with the washer.
• Do NOT connect the ground wire to
plastic plumbing, gas lines, or hot water
pipes.
• Improperly connected grounding
conductors may cause electric shock.
• To ensure proper grounding, the washer
comes with a power cord featuring a
three-prong grounding plug for use in a
properly installed and grounded outlet.
Check with a qualified electrician or
service person if you are not sure about
the grounding.
• Do not modify the provided plug. If it
does not fit the outlet, call a qualified
electrician to install a proper outlet.
DC68-03768A-10_IB_WV9900M_EN.indd 21
Philips screwdriver
Level
• To prevent unnecessary risk of fire,
electrical shock, or personal injury, all
wiring and grounding must be done in
accordance with local codes, or in the
absence of local codes, in accordance
with the National Electrical Code, ANSI/
NFPA No. 70-Latest Revision (for the
U.S.) or the Canadian Electrical Code CSA
C22.1 – Latest Revisions and local codes
and ordinances. It is your responsibility
to provide adequate electrical service
for your washer.
Adjustable pliers
English 21
2023-06-27
7:18:34
Publicité
