GE JGP329 Instructions D'installation page 14

Installation Instructions
MAKING THE LP CONVERSION (CONT.)
[3] CHANGE COOKTOP BURNER
ORIFICES
Remove the top grates,
burner caps, and burner se
heads. te 0
=
Remove the spark
igniters from the burner
base (if required to
access the orifices).
Using a No. 15 "Torx"
head driver bit, remove
the screws holding the
burner base in position.
Remove This
Assembly
Orifice Spud Located
Through This Opening
Using a 7mm nut driver,
remove the top burner
orifices. These may be
accessed through the
hole in the cooktop.
Burner cap
Burner ,
head /
Burner
Spark igniter base
18,000 BTU Burner
fon some models)
Burner
Burner *
Spark igniter
14
[3] CHANGE COOKTOP BURNER
ORIFICES (CONT.)
On most burners, the orifices
have a spring-loaded retaining
ring around the hex head
to hold the orifice in the nut
driver during installation and
removal. A slight amount of
force is required to push the nut driver down over
the ring.
Retainer
Ring
NOTE: For orifices that do not have a spring-
loaded retaining ring, use pliers to hold the orifice
in position during initial thread
engagement or final removal to
avoid dropping the orifice in the
cooktop. Then use the nut driver
to tighten or loosen.