Stadler Form Mia Mode D'emploi page 7

• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• Never leave water in the water container when the appliance is not in use.
• Clean the water container every 3 days
• Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable from the socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician.
Setting up / operation
1. Place Mia at the desired location on a flat surface. Connect the network
adapter (8) to the device and plug the adapter into a suitable socket.
2. Remove the lid (1) to fill with water and fragrance.
3. Fill the water container (2) up to the maximum mark (MAX) with water.
No water may enter the air outlet opening (9). This will damage the ap-
pliance and will void any claim to the warranty. Important: please do not
carry Mia around whilst it is filled with water. The water could run into
the electronics.
4. Add 2–3 drops of your favourite liquid fragrance directly into the water.
It is not necessary to mix them as the ultrasonic membrane (4) does this
for you. If the fragrance is not intense enough, you can increase the number
of drops.
5. Close the lid (1) again.
6. Then start operating Mia by pressing the on/off switch (5). After doing
this the white LED at the front will come on. If this does not happen, check
whether there is sufficient water in the device or if the adapter is con-
nected to the electricity supply. With a full water container (up to the MAX
mark), the runtime is approx. 10 h. The appliance switches off automati-
cally when the water container is empty.
7. If you would like to top the water up, switch the device off and pull the net-
work plug out. Remove the lid and fill the water up to the maximum mark.
Note: If you would like to change the fragrance, empty Mia completely and
clean the water container with a damp cloth. Fill Mia once again and pour the
drops into the device following the instructions.
Cleaning
Before maintenance and after every use, switch the device off and pull the
network adapter out of the socket. Before you clean Mia, the network adapt-
er must be unplugged.
Careful: Never immerse the device in water (danger of short circuit).
• To clean the outside, rub with a damp cloth and then dry thoroughly.
• Internal cleaning: You can clean the ultrasonic membrane with a conven-
tional household descaler. If there are lime deposits, we recommend that