Bosch CTL636E Serie Mode D'emploi page 42

38
Touch display (left and right)
Depending on the setting, different fields
are shon in both the touch displays. A field
is activated when touched either to enter
settings or change values�
Initial use
General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines)� Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit�
A Before the appliance can be
switched on and used, it must
be assembled and connected
according to the enclosed assembly
instructions�
Setting up the appliance
● Remove any protective plastic film.
F Important: Only use the appliance
in a frost-free room� If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use�
● Take hold of the appliance door by the
recessed grip and open�
● Remove the water tank, rinse it and fill it
with fresh water up to the "max�" mark�
● Replace the water tank and click into
place�
● Remove the bean container, fill with
coffee beans and replace�
● Set the mains switch to I and close
the appliance door�
The appliance heats up and is rinsed�
The control panel is activated�
"Language" appears�
Robert Bosch Hausgeräte GmbH
● Turn the control ring with your finger to
select the desired language and touch the
[ Water hardness ] field.
F It is important to set the water hard-
ness correctly to enable the appli-
ance to accurately indicate when the
descaling programme should be run�
The preset water hardness is level 4�
If a water softener is installed in the
house, please set the water hard-
ness to level 3� You can also check
the water hardness by asking your
local water supplier�
● Use the enclosed test strip to determine
the water hardness. Briefly dip the test
strip in water and check the result after
one minute�
Level Water hardness
German (°dH) French (°fH)
1 1-7
2 8-14
3 15-21
4 22-30
● Turn the control ring with you finger to set
the water hardness determined�
● Touch [ S et-up complete ] � The settings
are saved�
The appliance is ready to use as soon
as the drink symbols are shown and the
m lights up�
The integrated fan switches on each time
a drink is dispensed and switches off again
after a few minutes�
When the appliance is used for the first time
after running a service program, or if it has
not been operated for a long period, the first
beverage will not have the full aroma and
should not be consumed�
en
1-13
14-25
26-38
39-54