Yamaha RX-V350 Mode D'emploi page 44

SET MENU
SOUND 2 SP DISTANCE
(speaker distance)
Use this feature to manually input the distance of each
speaker and adjust the delay applied to respective
channel. Ideally, each speaker should be the same
distance from the main listening position. However, this is
not possible in most home situations. Thus, a certain
amount of delay must be applied to the sound from each
speaker so that all sound will arrive at the listening
position at the same time.
1
Press u / d to select "UNIT".
2
Press – / + to select the unit "meters" or
"feet" to be used in setting.
3
Press u / d to select a speaker.
4
Press – / + to set the distance.
Press + for higher values and – for lower values.
L
SL
I Setting by "meters"
Control range: 0.3 to 24.00 m (for front L/R, center,
surround L/R)
Initial settings: 3.00 m (for front L/R, center,
surround L/R)
I Setting by "feet"
Control range: 1 to 80 ft (for front L/R, center,
surround L/R)
Initial settings: 10.0 ft (for front L/R, center,
surround L/R)
Note
• No delay will be set if you set the same distance for the front
L/R and center, or the surround L/R.
42
C
R
C
SR
SOUND 3 LFE LEVEL
Use to adjust the output level of the LFE (low-frequency
effect) channel according to the capacity of your
subwoofer or headphones. The LFE channel carries low-
frequency special effects which are only added to certain
scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.
Control range:
SPEAKER ............ –20 to 0 dB
HEADPHONE ..... –20 to 0 dB
Initial setting: 0 dB
1
Press u / d to select the item to be
adjusted.
2
Press – to adjust the LFE level.
Note
• Adjust the LFE level according to the capacity of your
subwoofer or headphones.
SOUND 4 D. RANGE
(dynamic range)
Use this feature to adjust the dynamic range. This setting
is effective only when the unit is decoding Dolby Digital
signals.
Choices: MAX, STD (standard), MIN (minimum)
MAX
Select MAX for feature films.
STD
Select STD for general use.
MIN
Select MIN for listening to sources at low volume levels.