Bentel Security VRP-433 Instructions D'installation page 7

Depending on the charge state of the battery, a low battery trouble condition may be registered
on initial power up. The trouble may take several hours to clear.
Figure 3: Removing the Cover
To connect the AC adaptor:
1. Run AC wire through channel on back of VRP-433 and pass through hole in enclosure.
Figure 5: Wire Routing
2. Connect AC wires to terminals on PC board (see Figure 4).
3. Route wire around retaining bracket to secure.
4. Plug AC adaptor into wall outlet.
Figure 4: Power Connections
4
Battery
AC
Connector
Terminals