Assembling The Juicer; Installing The Juicer - Brandt CEN-700 Manuel D'instruction

C. Assembling the juicer
D. Installing the juicer
1. Place the assembled juicer on a flat, stable surface.
2. Set the control knob to position 0
3. Before plugging in the juicer, make sure the parts are correctly fitted and in place on
the motor base.
The juicer has a safety lock system to ensure the appliance can only be connected if
the accessories are correctly fitted to the unit.
Pull the power cord out of the cord
1.
storage compartment at the back of the
appliance.
Place the juice collector into the appliance
2.
Put the filter on the motor base. Make sure
3.
the filter is fitted securely onto the clutch
("click").
The filter is very sharp; handle it very carefully to
avoid cutting yourself
Place the pulp container on the appliance.
4.
Insert the top first and then push the bottom
end.
Put the lid on and raise the safety lock handle
5.
over the lid. Push it gently until it locks the lid
firmly in place.
Slide the pusher into the feeding tube by
6.
aligning the groove in the pusher with the
small protrusion on the inside of the feeding
tube.
Place the juice jug under the spout. Place the
7.
lid on the juice jug to avoid splattering or if
you want to store the juice in the refrigerator.
To separate the foam from the juice when
8.
pouring the juice into a glass, insert the foam
separator by sliding it into the juice jug.
14