Spdif Out; Analogue Output - Solid State Logic XLogic Alpha Channel Manuel D'installation

2. Connect
Lite Limit Link (daisy-chain to other Alpha Channel units)
Linked units have the same degree of 'limiting'; useful for stereo signals
~ 50/60Hz
100 - 240VAC
0.4 - 0.2A
POWER
AC Line Power
100 – 240Vac ~50/60Hz
Alpha Channel's SPDIF Out will run at 44.1kHz unless
an external SPDIF Sync is provided (32kHz ~ 108kHz).
Connections (Front Panel – see overleaf)
Microphone 3-pin XLR-F
0V
Pin 1
+ve
Pin 2
–ve
Pin 3
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This equipment must be earthed. Refer to manual for installation instructions.
CAUTION! Disconnect all power sources before removing any panel(s).
No user-serviceable parts inside - to be serviced only by qualified personnel.
WARNING! Unearthed parts may be present inside enclosure.
Check for hazardous voltages before touching.
Do not expose to rain or moisture
SPDIF In
Left stream:
Right stream: Pre- Insert Send signal
Instrument ¼" Mono Jack
Signal
Tip
0V
Sleeve
Insert Send/Return*
Balanced, level relative to output: 0dB (Lite Limit out)
* Only active whilst the Insert is switched 'IN'
LINK
ANALOGUE INSERT
OUT SEND RETURN
IN OUT
SPDIF

Analogue Output

Balanced, max. output: +24dBu = 0dB FS

SPDIF Out

Main Analogue Output (0dB FS = +24dBu)
Connections (Rear Panel)
Tip
Ring
Sleeve
+12dB (Lite Limit in)
Solid State Logic - Oxford - England
ALPHA Channel
Part no. 629999XA
Serial No
12345
MANUFACTURED IN U.K.
Phono ¼" Stereo Jack
Signal +ve
n/a –ve
0V 0V
EN
DE
FR
ES
IT
3