Disassembly
Step 1: With a screwdriver, carefully work the rubber vac-
uum pad down over the lip of the Outer Housing.
Step 2: Lift the Outer Housing straight up off of the chas-
sis. Squeeze the tabs on the Bumper Clips (inside the
housing) to remove the Bumper. The Bumper, Bumper
Boots, and Bumper Clips pull apart.
Step 3: Squeeze and pull the Sprocket Clips to release the
Drive Shaft Assembly and Center Sprocket.
All manuals and user guides at all-guides.com
3900 0201
Step 4: Pull the Oscillator Straight out from the bottom of
the Outer Housing. Be careful not to lose the Sliding Seals.
3901 0201
Step 5: Squeeze the latching tabs and pull up on the
Swivel Housing and Swivel. The assembly will come up,
releasing the Swivel Sprocket. Squeeze the latching tabs to
remove the Clutch Clip.
Step 6: Remove the Shaft Plug with the stainless steel shaft
and the Large Steering Drive Assembly.
8
3904 0201