Télécharger Imprimer la page

STA-RITE PoolShark S788 Manuel De L'utilisateur page 4

Publicité

Les langues disponibles

Les langues disponibles

Step 5: Adjust valves for vacuuming (Figure 5)
Decide on the vacuum connection you are going to use
(either a skimmer or a dedicated wall fitting) and adjust
the pump valves (if your system has valves) to direct all
vacuum there.
Close the main drain (also see "About Fine Tuning the
Vacuum", Page 7).
Vac
Port
Figure 5
Step 6: Install Regulator in Pools with a Dedicated
Vacuum Port
The pool regulator adjusts the amount of vacuum in the
line for optimum cleaning.
If your pool has a dedicated wall fitting in addition to the
skimmer, follow the procedure below.
1. Turn off the pool pump.
2. Place the regulator in the skimmer as shown. The cap
must be placed in the top.
Use the adapter cone if needed.
Skimmer
Figure 6 - Regulator in Skimmer.
All manuals and user guides at all-guides.com
Skimmer
Cap
Regulator
Adapter Cone
To Pump
3. Attach one length of hose to the vacuum port.
Hose
End
Figure 7 - Vacuum Port Connection.
Step 7: Pools with only a Skimmer
1. Turn off the pool pump.
2. Place the regulator in the skimmer as shown. Do not
install the cap.
Use the adapter cone if needed.
Skimmer
Figure 8 - Regulator in Skimmer.
3. Submerge one length of hose so it becomes filled
with water.
4. Insert the "male" end of the hose into the regulator.
4
Vac Port
Fitting
Regulator
Adapter Cone
To Pump

Publicité

loading