Axis A9210 Manuel D'installation page 8

AXIS A9210 Network I/O Relay Module
Specifications
• Operating conditions
UL 294
• Wiring requirements
• Connectors
or unconsumed lithium remaining. For information
about how to dispose of used lithium batteries,
contact your local authority for waste disposal.
- UL listed or R/C AWM wires that have a conductor
gauge range of AWG 22–14 shall be used.
- The minimum conductor gauge for connection
between the power sourcing equipment (PSE) or
power injector and the powered device (PD) is
26 AWG.
- Minimum PoE category 5e, shielded cable, required
for PoE.
- This product is not intended for outside wiring as
covered by Article 800 in the National Electrical
Code, NFPA 70.
- Power Connector – For UL security applications,
the product shall be powered by a UL 294 or
UL 603 listed Class 2 low-voltage power SELV and
limited power supply with appropriate ratings.
- External power to relays - If the relays are
connected to an external power source this must
0 °C to 70 °C (32 °F to 158 °F)
Humidity: 10–85% RH
(non-condensing)
Intended for use in UL listed
enclosure with tamper switch.
8