Axis A9210 Manuel D'installation page 6

AXIS A9210 Network I/O Relay Module
Requirements for compliance with UL 294
This section contains information and instructions required for UL
compliance. To make sure the installation is UL compliant, follow the
instructions below in addition to the general information and instructions
provided throughout this document. In cases where pieces of information
contradict each other, the requirements for UL compliance always replace
general information and instructions.
Performance levels for access control
This section contains performance level information required for UL 294
compliance.
Feature
Destructive attack test
Security
Endurance
Standby power
Safety instructions
• Shall be installed in accordance with Article 725.121 of the
National Electrical Code, ANSI/NFPA 70.
• The Axis product shall be installed and serviced by a factory
trained professional.
• The Axis product shall be installed within the protected
premises (secured area).
• The Axis product shall be mounted indoors. Outdoor use has
not been evaluated or approved by UL.
Level
I
I
IV
I
6