Westfalia WS 650-115 Mode D'emploi page 41


Make sure the cutting disc cannot get jammed or laterally
stressed while cutting. The cutting disc must be inserted
straight into the cutting gap of the workpiece.

Always try to cut the workpiece in one go.
ON/OFF Switch
1. To turn the angle grinder on, press down the rear part of the
ON/OFF switch (3) and push the switch forward. The angle
grinder starts up.
2. To switch off the angle grinder, press the rear part of the
ON/OFF switch ald let it slide back.
 Should the power supply fail during operation the angle grinder
will not start up if the ON/OFF switch is still set to on once the
power returns set the ON/OFF switch to OFF and then back to
ON to restart the angle grinder.
Hints for Operation
 When using the angle grinder for cutting, avoit tilting the angle
grinder out of the cutting line. It is advisable to use diamond
discs when cutting hard stone.
 For the best results while rough grinding hold the machine
against the surface in an angle between 30° and 40° in
smooth, even movements.
 The maximum permitted speed of the disc must be equal to or
higher than the maximum no load speed of the machine. The
maximum permitted speed of the cutting disc is printed on the
disc.
 Use only cutting or grinding discs with a maximum permitted
rotation speed of 12000 revolutions per minute.
 Never cut materials containing asbestos with this angle grider.
Operation
37