Publicité
Les langues disponibles
Les langues disponibles
Before first Use
Remove the angle grinder and the accessories for the packaging.
Keep packaging material out of reach of children. There is risk of
suffocation!
Intended Use
This angle grinder is intended for cutting and grinding metal and
stone with the suitable discs.
Setup
Please make sure the power mains voltage corresponds to the
operating voltage stated on the type label.
Attaching the Auxiliary Handle
Do not operate the angle grinder without the auxiliary handle (2).
There are threaded mounting holes on eiter side of the
transmission housing to which the auxiliary handle can be
attached.
Regulating the Speed
Use the speed regulator (10) to set the speed of the machine
sander in order to match the material which is to be machined.
1. Turn the regulator to position 1 for low speed and to position
6 for max. speed.
2. During operation it is also possible to infinitely adjust the
speed with the sped regulator.
Inserting/Changing the Grinding Disc
Please Note! Always pull the power plug before changing a disc
to avoid accidental starting.
1. Lossen the outer flange with the included face wrench. Keep
the shaft lock (5) pressed to lock the drive shaft and the disc.
Operation
34
Publicité
