Publicité
Les langues disponibles
Les langues disponibles
a. If you don't select a heat zone within 1 minute, the induction hob
will automatically switch off. You will need to start again at step 1.
b. You can modify the heat setting at any time during cooking.
c. Press "-", power will decrease by one stage each time till stage 0.
Press "+", power will increase by one stage each time till stage 9.
If the display flashes
setting
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minutes if no suitable pan is placed
on it.
When you have finished cooking
1. Touching the heating zone selection control that you wish to
switch off.
2. Turn the cooking zone off by touching the "-" and scrolling down to"0",or
holding the "+" and "-" button at the same time for 1 second, it will cut down
to "0" directly.
Make sure the power display shows "0", then shows "H".
alternately with the heat
and then
EN-12
Publicité
