Kin HNB 400 Auto A Mode D'emploi page 7

Connecting Pressure Pipe
1. Screw the pressure pipe onto the pressure connector. All joint
connections must be sealed with a threaded sealing stripe.
2. When using the hose, screw the right hose adapter into the pressure
connector.
3. Secure the hose firmly to the hose adapter and secure it with a hose
clamp.
4. If it is used occasionally, please use a suitable pipe. A rigid pipe with a
check valve is recommended for use in a fixed position. This can be
done at the close of the machine to prevent liquid backflow.
3. Operation
Use a strong rope to connect the handle of the pump and dip it into the
liquid to be conveyed at a certain angle, so that the lower side of the device
has no bubble formation to prevent the bubbles from being sucked in. Put
the equipment down slowly, and once the pump is submerged, it can be
adjusted again. The pump is arranged at the bottom of a liquid container.
Fasten the end of the rope after lowering so that the pump can also be
handled when hanging on the rope. The pump can work after the device is
connected to the main power source.
The pump is not allowed to transport corrosive substances, flammable and
explosive substances (such as gasoline, petroleum, nitro diluent), grease,
oil, brine and toilet equipment sewage, as well as low mobility mud
sewage. The temperature of the liquid cannot exceed 35 °C.
kinpumps.com
HNB 400 Auto A
7
GB