FAR DP2621IL Mode D'emploi page 34

ENGLISH
9. Position the middle
hinge on the left of the
refrigerator and insert the
gun of hinge in the hole
of the door then fix it
firmly.
10. Remove the door stop of the Freezer door
and put it to the opposite side. Align the
lower hole of the door to the gun of the
left middle hinge while taking care of the
alignment of the door compared to the
refrigerator.
11. Insert the gun of the
upper hinge in the upper
hole of the door then fix
it firmly.
12. Replace and secure the
top cover. Replace the
hole covers.
GB-24
MAINTENANCE
Fridge defrosting
The fridge defrosting process is carried out
automatically every time the compressor stops.
The defrost water is automatically routed to the
drain port and into a tray placed on the top of
the compressor to the rear of the appliance from
which it evaporates.
Make sure the drain port on the fridge at the
rear of the appliance is kept clear.
Freezer defrosting
Frost will accumulate inside the freezer
depending upon the length of time during which
the door is left open or the amount of moisture
introduced. It is essential to ensure that no
frost or ice is allowed to form at places where
it will affect the close fitting of the door seal.
This might allow air to penetrate the cabinet,
thus encouraging continuous running of the
compressor.
ENGLISH
GB-25