Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Setting the thermostat knob
• The refrigerator is controlled with a thermostat
knob located inside the fridge, towards the
upper right-hand corner. Turn the knob from
the STOP(0) position towards the higher
numbers fro colder temperatures. The knob
can be adjusted from setting 1 to 7.
• Higher settings on the knob(higher numbers)
mean lower temperatures(colder) in all
compartments of the appliance.
• Changes of the ambient temperature affect
temperatures in the interior of the appliance
so choose a correct setting of the temperature
control knob, depending on your ambient
conditions.
• In the STOP(0) position the appliance does
not operate(the cooling system isswitched off),
but power supply is not interrupted.
• Set the thermostat knob to a middle position
to achieve -18°C in the freezer compartment.
• Please Note: If the appliance is switched
off you must wait at least 5 minutes before
restarting the appliance or re-inserting the
plug into the wall outlet.
• This is to allow the protection device in the
GB-12
compressor to reset.
• If the compressor fails to start correctly
remove the plug and wait for 5 minutes before
you try again then the compressor should
restart normally.
• The storage temperature may be affected by:
– The room temperature
– How often the door is opened
– How much food is stored
– Position of the appliance
• When you set the correct temperature, all
these factorys mentioned above shall be taken
into account.
Temperature Indicate
In order to help you get the correct
adjustment of your device, it is
equipped with a temperature gauge
placed in the coldest area.
For the proper storage of food in
your refrigerator and in particular
in the coldest area, make sure that
«OK» appears in the temperature
indicator.
ENGLISH
GB-13
Publicité
