Fitting The Blade; Stopping The Machine - Husqvarna FS 400 LV Manuel D'utilisation

reverse two of the supply wires.
6 – FITTING THE BLADE
Motor off.
Disconnect by removing the plug.
•
Set the machine in the high position.
•
Disconnet the water pipe from the blade guard.
•
Unscrew the nut (K) from the guard [FIG. 1].
•
Lift up guard (A).
•
Fit the diamond blade.
Take care about the direction of
rotation which is shown by an arrow
on one of the faces (direction of
rotation on the right side of the guard)
Make sure the contact faces of flanges
(B and C) of blade and the axle are
clean.
•
Firmly lock screw (D) using the spanner supplied
with the machine whilst immobilising the blade by
hand.
•
Replace the protection guard (A).
•
Close the guard water tap (G) [Fig 2].
•
Reconnect the water pipe (G).
•
Tighten nut (K).
Replace all protective covers for your
safety and that of other persons.
Note : how to adjust the « zero » according to the
diameter of the blade :
•
The blade must be closed to the floor.
•
Loosen the screw (H) [FIG. 3]
•
Line up the « zero » with the pointer, then tight
the screw (H).
7 – STARTING UP
Danger : risk of injury.
Always pay extreme care and attention
to the preparation of the machine
before starting up.
Remove all adjustment tools and
wrenches from floor and machine.
Always keep blade guard in place.
•
Fill the tank with water, or connect with the water
network.
•
Mark the floor by drawing a line in the place to be
cut.
•
Fold down the front guide and position the
machine so that the guide (F) and the blade line
up with the mark.
Engine :
- Start the engine: refer to
the instructions in the
manufacturer's
manual.
- Allow the engine to
warm up.
•
Open the water inlet tap (G).
•
Increase the engine speed to maximum.
•
Low the wheel lock (E) [FIG.3], in order to turn
the wheel (2).
•
Lower the blade to the desired depth indicated on
the side scale on the ratchet placed on the side.
We recommend a slow descent to avoid stalling
the engine.
•
Start moving down to the depth of cut required,
indicated on the gradiated scale fitted on the side.
A slow descent is recommended to prevent
stalling the motor.
•
Once the required depth is reached, lock the
wheel (2) by raising the block wheel (E).
Ensure that the water supply is
abundant, when cutting wet.
8 – STOPPING THE MACHINE
Moteur off.
•
Low the block wheel (E) [FIG.3] and turn the
whell (2) to release the blade from the groove.
•
Lock the machine in the high position by means
of the block wheel (E).
•
Turn off the water supply.
•
Allow the engine to turn at low speed.
•
Stop the engine (consult the engine maintenance
manual).
Emergency stop (engine) : Operate the
switch on the machine's control panel.
English - 4/6
Electric motor :
- Switch on by pressing
knob I on the circuit
service breaker.