Publicité
Les langues disponibles
Les langues disponibles
Problem
Pump Does Not Start
Pump Won't Prime
Low Water Flow
Pump being noisy
9. ERROR CODE
Corrective solution
•Power Supply fault, disconnected or defective wiring
• Fuses blown or thermal overload open
• Check the rotation of the motor shaft for free movement and
lack of obstruction.
•Because of long timelying idle. Unplug the power supply and
manually rotate motor rear shaft a few times with a screwdriver.
• Empty pump/strainer housing. Make sure the pump/strainer
housing is filled with water and the cover o ring is clean.
•Loose connections on the suction side.
•Strainer basket or skimmer basket loaded with debris.
•Suction side clogged.
•Distance between pump inlet and liquid level is higher than 2.5m,
height of pump installation should be lowered.
•Pump is not primed
•Air entering suction piping
•Basket full of debris
•Inadequate water level in pool
•Air leak in suction piping, cavitations caused by restricted or
undersized suction line or leak at any joint, low water level in pool,
and unrestricted discharge return lines.
•Vibration caused by improper installation, etc.
•Damaged motor bearing or impeller (need to contact the supplier
for repair)
9
Publicité
