Installation Instructions; Electrical Connection - Screen Research MS2-IT Manuel D'installation

Rolling screen installation and operation manual
WARNING: See images on the end pages of this manual. It 's absolutely forbidden to install the screen on mobile walls or unstable cables,the brackets must be applied on surfaces that
ensure in the time your distance. When installing the screen use plugs and screws suitable for the screen's weight and for the type of wall or ceiling on which the mount brackets are to
be fixed, based on the following criteria
Screen width view area up to inches
Overall weight
The type of motor installed on the product is identified by a label applied on each product showing the CE logo. When unwrapping the product please check the model type indicated on the label in order to
perform the installation and cable connections correctly. Should the power of the motor be different from that of the supply network of the installation place, please contact an electrician to have a current and
Hz transformer installed.
electric cabling must be conformant with applicable IEC standards. IEC norm EN 60335-1 requires that supply network be fitted with an omnipolar
selector switch with contact opening distance of at least 3 mm. For the screen's control use only the selector switch provided by manufacturer, or
equivalent model. The selector switch must be mounted within sight distance of the product, at a 1.5 - 1.8 m height from the floor.
Correctly performed, state-of-the-art, norm-compliant electrical connections are important to prevent accidents and to ensure the screen's optimal and
unaltered performance over time. Prior to carrying out any operation on electrical parts ensure that power supply is disconnected. In screens fitted with
cases the motor is positioned on the right-hand side of the screen as seen from the front (upon request it can be located on the left). Never connect two or
more motors to the same selector switch without a control unit or two switches to the same motor..
Made by Adeo Screen Sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Please verify that you are working with the latest revision of this document before specifying your screen.
Doc: MS2-IT – Installation Manual rev2 | 01.01.2018

07 INSTALLATION INSTRUCTIONS

80
Kg 52
– lbs 114
09 MOTOR TYPE IDENTIFICATION –CHARACTERISTICS – ELECTRICAL CONNECTION

ELECTRICAL CONNECTION:

WARNING:
90 96
Kg 56 Kg 58
– lbs 124 – lbs 128
ENGLISH
100 110
Kg 60 Kg 65
– lbs 132 – lbs 142
230V 50Hz
Motor characteristics:
Frequency: ~Hz50
Power: 120W
Torque: 6Nm
Speed: 32Rpm
Duty cycle: S2 4min
Mechanical strength: EN14202 conformant
Operating T°: from –20 to +55 °C
Weighted sound pressure level:
LpA ≤ 70 dB(A)
Motor protection class: IP44
120V 60Hz
Motor characteristics:
Frequency: ~Hz60
Power: 110W
Torque: 6Nm
Speed: 38 Rpm
Duty cycle: S2 4min
Mechanical strength: EN14202 conformant
Operating T°: from –20 to +55 °C
Weighted sound pressure level:
LpA ≤ 70 dB(A)
Motor protection class: IP44
Page 8