Ego Power+ LM2102SP-A Guide D'utilisation page 138

ADJUSTING THE TRIMMER
HEIGHT
If the length of the shaft is not suitable for
operation, you can adjust the length of the
shaft with the height-locking clamp.
1. Remove the battery pack from the
trimmer.
2. To adjust the trimmer height (i.e.,
shaft length), open the height-
locking clamp, and then slide the shaft up or down to desired height, securing it
in place by depressing the height-locking clamp. (Fig. 11)
NOTICE: The front handle may need to be repositioned after the trimmer height is
changed.
ATTACHING SHOULDER STRAP
(SOLD SEPARATELY, MODEL
NUMBER: AP1500)
For safe and better operation, put the
strap over one of your shoulders and
across your back.
1. Loosen the screw knob and hex nut
from the shoulder strap loop.
2. Attach the shoulder strap loop onto
the shaft within the installation zone (Fig. 12).
3. Tighten the screw knob and hex nut.
56-VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1620/ST1620-FC
11
12
Screw Knob
Shoulder Strap Loop
Height-Locking Clamp
Hex Nut
17