Télécharger Imprimer la page

Tripp-Lite PDU1230 Manuel Du Propriétaire page 2

Publicité

Les langues disponibles

Les langues disponibles

Important Safety Instructions
This manual contains information concerning the proper installation
and use of Tripp Lite's PDU Rackmount Power Strips.
SAVE THESE INSTRUCTIONS.
Do not connect your power strip to an ungrounded outlet. Do not use it with extension
cords or adapters that eliminate its connection to ground. Your power strip is designed
for indoor use only. Install it away from heat emitting devices such as radiators and
heat registers. Do not install where excessive moisture or other conductive
contaminants are present. Never install electrical wiring during a lightning storm.
The power requirement of each device connected to an outlet of your power strip must
not exceed the Outlet Power Rating of your power strip. The total power requirements
of all devices connected to your power strip must not exceed the Maximum Load Rating
of your power strip.
Installation
1U Rackmount
Installation
To Mount Unit in Rack: Put four user-sup-
plied rackmount screws (A) through the
unit's mounting ears (B) and into the rack
rails as shown. The user must determine
the fitness of the rackmount screws to
hold the unit in the rack before installation.
0U Rackmount
Installation
1. Reorient Mounting Ears: Unscrew the
screws (A) holding the unit's mounting
ears (B) to the sides of the unit. Use
the screws from Step 1 (A) to reattach
the mounting ears (B) to the unit as
shown. Use only the manufacturer-sup-
plied screws or their equivalent (#6-32,
¼" flat head) to reattach the mounting
ears.
2. Mount Unit on Outside of Rack Rails: Put four user-supplied screws (C) or similar mounting
hardware through the unit's mounting ears (B) and into the side of the rack as shown. The user
must determine the fitness of the user-supplied mounting hardware to support the unit before
mounting.
Wallmount/Under Counter Installation
Reorient the unit's mounting ears as per the 0U Rackmount Installation above, then put four user-
supplied screws or similar mounting hardware through the unit's mounting ears and into the
mounting surface. The user must determine the fitness of the user-supplied mounting hardware to
support the unit before mounting.
14-02-326-932263.indb 2
1U Rackmount Installation
2
0U Rackmount Installation
3/25/2014 12:43:49 PM

Publicité

loading