Dyna-Glo DGE530BSP-D Mode D'emploi page 8

asseMBLY insTruCTiOns
3. Insert one screw (AA) into the rear holes of the
cart left side panel and cart right side panel
(H&E), leaving 4-6mm clearance from screw
head to the side panels (H&E). Attached the
cart rear panel (I) by sliding the keyholes in
the cart rear panel over the inserted screws
and then push with force. Secure the cart
rear panel (I) to the bottom shelf (A) using 3
screws (AA). Tighten the 2 screws on the side
panels (H&E).
Hardware Used
M6x12 Screw
AA
4. Align upper front door brace (Y) to the holes
1 on cart left side panel (H). Secure upper
front door brace to 2 using 2 screws (AA).
Repeat and secure upper front door brace (Y)
to cart right side panel (E).
Hardware Used
M6x12 Screw
AA
3
I
x 5
4
AA
E
x 4
Y
8
AA
E
A
1
Y
H
Y
H
2
H