Installation Instructions - GE 20 Série Manuel D'utilisation Et D'installation

Installation
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
)
(on some models
If the refrigerator has an icemaker, it will have to be
connected to a cold drinking water line. An approved
water supply kit is available at extra cost from your
local distributor.
Maximum permissible inlet water pressure—8.3 bars.
Minimum permissible inlet water pressure—1.4 bars.
Installation of the icemaker must be done by a
qualified service technician.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 16°C because it will not run often enough
to maintain proper temperatures.
• Install it on a floor strong enough to support it fully
loaded.
Save these
Observe all
Be sure to leave these
Keep these instructions
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
• Sides 4 mm
• Top 25 mm
• Back 25 mm
A side clearance of 19 mm is needed for a 90° door
opening which provides better access to the food
storage area.
DIMENSIONS
20
A* 1689 mm
B 800 mm
C** 864 mm
D 1216 mm
E 1207 mm
F 1018 mm
G 1159 mm
H 1123 mm
*Height does not include hinge.
**Depth includes handle.
A
B
C
14
Refrigerator
Models 20, 22, 25
22
1689 mm 1746 mm
851 mm 908 mm
864 mm 864 mm
1267 mm 1267 mm
1076 mm 1207 mm
1074 mm 1113 mm
1233 mm 1294 mm
1172 mm 1171 mm
E
H
D
G
25
F