Automatic Icemaker; Icemaker Accessory Kit - GE 20 Série Manuel D'utilisation Et D'installation

About the automatic icemaker.
A newly-installed refrigerator may take 12–24 hours to begin making ice.
Power
Switch
Icemaker
Green
Feeler Arm
Power Light
10

Automatic Icemaker

(on some models)
The icemaker will produce seven cubes
per cycle—approximately 100–130 cubes
in a 24-hour period, depending on freezer
compartment temperature, room
temperature, number of door openings
and other use conditions.
If the refrigerator is operated before the
water connection is made to the icemaker,
set the power switch in the O position.
When the refrigerator has been connected
to the water supply, set the power switch to
the I position.
The icemaker will fill with water when it
cools to freezing. A newly-installed
refrigerator may take 12 to 24 hours to
begin making ice cubes.
You will hear a buzzing sound each time the
icemaker fills with water.
Throw away the first few batches of ice to
allow the water line to clear.
Be sure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the level of the feeler
arm, the icemaker will stop producing ice.
Ice Storage Drawer
To access ice, pull the drawer out.
To remove the drawer, pull it straight out
and lift it past the stop location.

Icemaker Accessory Kit

If your refrigerator did not come already
equipped with an automatic icemaker,
an icemaker accessory kit is available at
extra cost.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale and shrink. If the
ice cubes become stuck in the icemaker, turn
off the icemaker, remove the cubes and turn
the icemaker back on.
There is an upper freezer shelf
above the icemaker that can be
used for storage.
WARNING: Connect to potable water supply
only. Installation of the icemaker must be
done by a qualified service technician.
Check the back of the refrigerator for the
specific icemaker kit needed for your model.
WARNING: Connect to potable water supply
only. Installation of the icemaker must be
done by a qualified service technician.