Publicité
Les langues disponibles
Les langues disponibles
Note: During normal operation, the inlet valve shall be set in the status
of "open".
2.
Insert the supply plug into the socket, the two indicator lights will be on at
the same time..
3.
This machine can automatically control the temperature. When the water
temperature inside the machine has reached the set temperature (It is set
to 75℃), it will be turned off automatically, and step into the status of
thermal insulation; when the water temperature is decreased to a certain
point, it will be turned on automatically to restore the heating, and the use
of hot water will not be interrupted. When the heater is switched off auto-
matically, the heating indicator will turn off.
4. Operating Of The Unit
①
"1" button is for frequency switch. When press firstly, display screen "4"
will show the three frequency option( index number "1" means 1200W,
index number "2" means 2000W , index number "3" means smart control
energy saving mode) , The number "3" of light "6" will blink on the screen .
②
"2" is the on/off button, when press , water heater start working,display
screen will be lighted up. Then press again, electricty will be cut off, and
display screen will be shut down.
"3" is for temperature adjustment knob with 360 °loop. Temperature
③
increases by clockwise rotation, and decreases if anticlockwise. During
the rotation , desplay screen " 4" will change accordingly. When temperature
setting meets customers' requirements, stop rotating and display screen
"4" will flash for around 3 seconds, which means temperature has been
4
5
MODE
6
7
3
1
2
6
(Fig.7)
Publicité
