Publicité
Les langues disponibles
Les langues disponibles
Volume setting/Melody selection
Press the "Volume"/"melody forward/backward" button until you hear the required volume/melody.
You can change the volume at any time and this is independent of the corresponding transmitter. The
last selected volume is automatically saved.
You can still replay different bell tones by pressing "Melody forward/backward". This does not effect
the saved bell tone when coding between transmitter and receiver.
Installation
Choose a suitable location for the chime and bell push. Check the selected location for wiring before
drilling any holes.
Tip: Test the desired function before ultimately installing the device at the place of installation you
chose.
Chime: Screw the screws into the wall until they are only protruding by a few millimeters. Hang the
chime on the intended suspension clips.
Bell push: Mount the mounting plate using the enclosed screws. Push the bell push onto the moun-
ting plate or use the enclosed double-sided tape for mounting.
Troubleshooting
Error
description
The chime does not
sound
Range is low
11
Error correction
•
Check the batteries of the receiver (chime) and the transmitter
(bell push, motion detector, window contact). Change the
batteries if necessary.
•
Check whether the distance between the receiver (chime) and
transmitter (bell push, motion detector, window contact) is too far.
If necessary, reduce the distance, to get back within the range.
•
Check whether the receiver (chime) is coded with the transmitter
(bell push, motion detector, window contact). If necessary, code
the receiver and transmitter as described above.
•
Check the volume setting of the receiver (chime). Increase the
volume if necessary.
•
Check the mounting surface and the surroundings. Metal surfaces
can reduce the range. Avoid installation on or near metal.
•
Structural conditions (e.g. concrete walls or ceilings) can have an
effect on the range.
•
Other wireless products in the vicinity can have an effect on
the range. Change the location of the receiver (chime) and/or
transmitter (bell push, motion detector, window contact) or the
other wireless product.
•
Check the batteries of the receiver (chime) and transmitter (bell
push, motion detector, window contact). Change the batteries if
necessary.
Publicité
