Brandson Equipment 305374 Manuel D'utilisation page 10

5. Safety information
When you press the ignition button, the electric arc is only ignited for 7 seconds
and then switched off in order to preserve battery life. The flexible neck allows
access to hard-to-reach places and keeps your hands at a safe distance from the
igniter.
6. Charging
No gas or liquid is needed. You can charge the device's battery with the charging
cable provided. To do this, connect the charging cable to a 5V DC power source
(e.g. a smartphone charger) and to the microUSB port of the lighter. The product
can be connected to any charger with an output voltage of 5V DC and an output
current of 1.0 A. A full charge takes about 1.5-2 hours. During the charging
process, the blue indicator light flashes. After a complete charge, it can be used
approx. 80 to 100 times.
7. LED torch
Please switch on the device via the "On/Off switch". Press and hold the "LED
button" to switch on the LED light. Press the "LED button" again to switch off the
light.
8. Handling
Switch on the device via the "on/off switch". Press and hold the "ignition button"
to switch on the igniter. Release the button as soon as the ignition has occurred.
Switch the unit off via the "On/Off switch". The LED lighting and the igniter can be
used simultaneously.
9. Safety instructions and disclaimer
Never try to repair or modify the device by yourself. Avoid contact with the mains
supply. The device does not carry current only when disconnected. The device is
not approved for outdoor use. Therefore, please use it only in dry surroundings.
Protect it from high humidity, water and snow. Do not expose the device to high
temperatures. Do not expose the device to sudden changes in temperature or
strong vibrations, as this could damage the electronic components. Check the de-
vice for any damage before using it. The device should not be used if it has been
subject to impact or has been damaged in any other way. Please follow the nation-
al regulations and restrictions.
10
English