Amica SBSN 397 100 E Notice D'utilisation page 19

Smart ECO
When Smart ECO is enabled the temperature is set to +5°C in the refrig-
erator compartment and to –18°C in the freezer compartment. These are
optimal temperature settings. To enable or disable Smart ECO, touch the
"Function" sensor repeatedly to cycle through available functions. When the
Smart ECO icon flashes, touch "OK" to confirm.
Note: If you do not touch "OK" within 5 seconds, the function will not be
activated. Smart ECO will be deactivated when you enable the Holiday or
Fast Freezing function.
Open door alarm
If the door remains open for more than 3 minutes, you will hear beeping.
Touch any sensor on the control panel to mute the beeping. After another
3 minutes, you will hear beeping again. Beeps will continue until you close
the door.
Non-volatile appliance settings and compressor protection
In the event of a power outage, the appliance settings will not be reset.
When the power is restored, the appliance will operate with the same set-
tings as before the power outage. If the power is restored within less than
5 minutes, the compressor will start with a delay. This prevents damage to
the compressor.
Elevated temperature alarm
If the temperature inside the freezer compartment is higher than –10°C
when you plug in the appliance to power, the freezer compartment temper-
ature will flash on the display. The temperature will stop flashing after a few
seconds or when you touch any sensor on the control panel.
Error Codes
Contact the service centre when E0, E1, E2, EH, EF or EC appears on the
display.
Inverter icon
This icon displays the status of the compressor. When the compressor is
running, the symbol lights up. When the compressor stops working, it will
automatically go out. To enable or disable the Inverter icon, touch the
"Function" sensor repeatedly to cycle through the available functions. When
the Inverter icon flashes, touch "OK" to confirm
Child Lock
The appliance features a child lock safety device. The Child Lock function
is especially useful when cleaning. The Child Lock function is activated
automatically 3 minutes after you last used the control panel or opened or
closed the door. Touch and hold the "OK" sensor for 3 seconds to deacti-
vate the Child Lock
- 19 -