Mitsubishi Diamond Pro 2070 SB Mode D'emploi page 5

Quick Start
To attach the Diamond Pro monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. If necessary, install the graphics card into your system. For more information,
refer to the graphics card installation manual.
3. For the PC: Connect the 15-pin mini D-SUB connector of the signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the Diamond Pro Macintosh cable adapter (not in-
cluded) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the signal cable to the Diamond Pro Macintosh
cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the Diamond Pro 2070
Mitsubishi Electronics Display of America, Inc. at (800) 632-4662.
4. Connect the other end of the signal cable to the connector on the back of the
Diamond Pro monitor.
5. Connect one end of the power cord to the Diamond Pro monitor and the other
end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
For download information on the Windows
NOTE:
Diamond Pro monitor, refer to the References section of this User's Manual.
If you have any problems, please refer to the Troubleshooting section of
NOTE:
this User's Manual.
15-pin
mini
D-SUB
Capative Signal Cable
Figure A.1
SB Macintosh cable adapter, call NEC-
98/2000/Me/XP INF file for your
®
Capative Signal Cable
Figure B.1
3
Mac Adapter
(Not Included)