Publicité
Les langues disponibles
Les langues disponibles
To activate this function, in standby state press and hold
seconds. If there is no operation within 10 minutes, the display will turn off.
To deactivate this function, press any button or turn the control knob. The display
will turn on again.
CLEANING AND MAINTENANCE
Switch off and disconnect the appliance from the power supply
and allow it to cool completely before cleaning.
Cleaning the outer surface
Clean the outside of the appliance with a slightly damp cloth
Dry it thoroughly. Never use abrasive or chemical cleaning agents.
Cleaning the inside of the oven (after each use)
Wipe the inside of the oven using a household detergent. Wipe
clean with a slightly damp cloth and dry thoroughly.
Cleaning removable accessories
Wash all the removal accessories in warm soapy water. Rinse and
dry them thoroughly before use.
Pyrolytic self-cleaning function
ATTENTION: Before starting the Pyrolytic cycle, REMOVE ALL THE ACCESSORIES FROM
THE OVEN to prevent them from getting damaged.
Excessive spillage must be removed before
cleaning.
Under such conditions, the surfaces may get
hotter than usual and children should be kept
away.
1. Turn the function knob until "PyR" appears on the display.
2. Press
to start cleaning. The default cleaning time is 2 hours (2:00).
3. To change the cleaning time, turn the function knob to select the cleaning time (1:30
or 2:00).
4. Press
to confirm the setting.
.
EN-13
for approximately 3
Publicité
