VOSS.farming easyCUT Mode D'emploi page 22

Fault /Problem
Upper blade does not
move over the entire
running surface
Clipper head gets very
hot
Blades cut badly
Blades do not cut
11 TRANSPORT AND STORAGE
WA R NI N G
»
Before storage, make sure that the unit is disconnected from the power supply.
»
Store the machine in an environment that is not accessible to children and
third parties to prevent misuse of the machine.
N OTICE
»
Do not store the device in direct sunlight.
»
Only store the device at an ambient temperature between 0°C and +40°C and
make sure that the environment is free of moisture.
»
To transport the unit, pack the unit so that it is protected from impact. Ideally,
use the original packaging.
»
Do not wrap the power cord around the unit. It may result in broken insulation
and cable damage.
12 DISPOSAL
The crossed-out wheelie bin symbol on the product or its packaging indicates that the
product must not be disposed of with normal household waste. End users are required
to hand in the appliance at a collection point for waste electrical and electronic equipment.
If the product contains a battery or a rechargeable battery, these should be disposed of
separately from the product if possible. As an end user you are legally obliged to return
22
Clippers head/Blades
Cause
1. Eccentric knocked
out
2. Eccentric shaft
defective
1. Blade tension is too
high
2. Blade or head are dry
1. Blade tension is too
low
2. Blades have rust on
them
3. Blades are dull or
poorly sharpened
1. Eccentric defective
2. Defective reduction
gearing
3. Clipper head knocked
out
INSTRUCTION MANUAL VOSS.FARMING EASYCUT
Solution
Contact the service department.
1. Adjust the blade tension with the
tensioning nut. If this solves the problem
and the machine stops cutting, the
blades must be sharpened.
2. Oil the blades/clipper head.
1. Increase the blade tension with the
tensioning nut.
2. Have the blades sharpened in a
specialist shop. If there is too much
rust, replace the blades with new ones.
3. Have the blades sharpened in a
specialist shop.
Contact the service department.
85285 - 10.2023 - V6