Publicité
Les langues disponibles
Les langues disponibles
Hold the adjustment knob and depress
the release lever to raise each side evenly
until the joint is almost closed. (see fig. 4)
Ensure mitered apron piece is in desired
final position.
Turn the adjustment knob clockwise to
fully close the joint. (see fig. 5)
Do not over-tighten, as this will cause the
joint to shift out of alignment.
Add tape between Miter-Its to tighten the
joint. (see fig. 6)
Leave the jigs in place until adhesive has
cured.
. 4
.5
.6
7
omnicubed.com
Publicité
