Zodiac Z250iQ Notice D'installation Et D'utilisation page 43

• Open the top panel ( ) with a screwdriver (4 screws) to access the electrical terminal block.
• Insert the power supply cable (
• Inside the appliance, fix the power supply cable by threading it through the cable clamp (
screw).
• Connect the power supply cable to the terminal block inside the appliance as following.
Connect to
power supply
Terminal block for single-phase power
• Carefully close the top panel.
) into one of the cable gland (
Accessing the electrical terminal block
Connect options
(filtration pump,
power supply
power supply relay),
see"1.4 I Option
connections".
Terminal block for tri-phase power
) on the rear part of the appliance.
L: Live
N: Neutral
: Earth
Connect options
Connect to
(filtration pump, power
supply relay)
) (maintained with one
EN
10