Publicité
en
Risk of damage caused by incor-
rect cleaning.
The pre-filter can become damaged
and be less effective as a result.
Do not clean the pre-filter with water.
Do not use pointed or sharp-edged
objects to clean the filter.
Clean the pre-filter with the dusting
brush supplied or with a dry cloth.
After cleaning the fine dust filter and
pre-filter, reinsert the former into the
latter by pressing the round cap on
top of the fine dust filter down as far
as it will go.
To continue achieving the best pos-
sible cleaning results, replace the fine
dust filter (HX FSF-2) with a new one
after approx. 3 years.
Reinsert the pre-filter in the dust con-
tainer (Fig. 36).
To do this, line up the guides (arrows)
and turn the pre-filter back to its ori-
ginal position (Fig. 37).
Close the dust container flap, making
sure it clicks into place.
Reattach the dust container to the
PowerUnit connector.
Cleaning the dust container
Clean the dust container as required.
Remove the dust container.
Empty the dust container over a bin
and lift the pre-filter upwards to re-
move it (Fig. 34).
Clean the dust container using water
and mild washing-up liquid.
80
Dry the dust container thoroughly.
Reinsert the pre-filter in the dust con-
tainer and turn the pre-filter back to
its original position (Fig. 36 + 37).
Reattach the dust container to the
PowerUnit connector.
Cleaning the Electrobrush (Fig. 38)
Disconnect the Electrobrush from the
vacuum cleaner (Fig. 10).
Place the Electrobrush upside down
on a level, clean surface.
Cut any threads or hairs that have
wound themselves around the roller
brush with a pair of scissors. To guide
the scissors, move along the guide
track on the roller brush.
Then run the vacuum cleaner to va-
cuum up the cut threads and hairs.
If the small running wheels are very
heavily soiled or blocked, you can re-
move them for easier cleaning. To re-
move them, use a flat-head screw-
driver.
Removing the roller brush from the
Electrobrush (Fig. 39)
You can take the roller brush out of the
Electrobrush in order to remove stub-
born soiling and clean the inside of the
Electrobrush.
Unlock the cover on the side of the
Electrobrush so that the symbol
becomes visible a.
Lift the cover up as far as it will go b.
Remove the roller brush c.
Publicité
