Perel FT120C Mode D'emploi page 4

4. Assembly
A
B
A
B
C
D
E
F
5. Installation
Install vertically on a flat, dry, stable and non-slippery surface.
Direct-fired heaters are intended for use in open outdoor areas or in well-ventilated indoor
spaces. For indoor use, provide permanent ventilation of at least 25 cm²/kW, equally
distributed between floor and high level, with a minimum of 250 cm².
Install the device in a normal upright position.
V. 05 – 23/04/2020
FT120C/FT130C
2x screw
2x plain washer
1x handle
6x or 8x screw
6x or 8x spring washer
6x or 8x plain washer
1x feet
6x or 8x M5 nut
FT120C
600 cm²
1x handle
C
2x M12 nut
G
2x wheel
H
2x Ø 12 plain washer
I
1x wheel shaft
J
2x cotter pin
K
FT130C
800 cm²
4 ©Velleman nv