Publicité
Les langues disponibles
Les langues disponibles
32
www.aeg.com
Problem
The temperature in the ap-
pliance is too low/too high.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
8.3 Replacing the lamp
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction
of the arrows.
9. INSTALLATION
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
CAUTION!
Disconnect the plug from
the mains socket.
WARNING!
Refer to Safety chapters.
Possible cause
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
There is no cold air circula-
tion in the appliance.
2. Replace the lamp with one of the
same power and shape, specifically
designed for household appliances.
(the maximum power is shown on the
light bulb cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light comes on.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
Solution
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
1
2
1
Publicité
