Wilfa HU-430CWA Manuel D'instructions page 13

OVERVIEW – DISPLAY
OVERVIEW – CONTROL PANEL
BEFORE USE
• Put the humidifier in the room 30 minutes before starting it.
• It is recommended to use the humidifier when the temperature is under 20°C,
and the relative humidity is less than 80%RH.
• Use clear water not over 40°C.
• Check the water basin, make sure it is clear.
• Place the humidifier on a flat surface.
USE
• Remove the top cover, fill water into the water tank, and put the top cover
back. Or take the water tank out, fill it with water, and put the water tank back
into the main base.
• Check if the rated voltage meets the input voltage and plug into the socket.
The display will light up and the buzzer ring for once. 1 second later, display
turns off and the humidifier is in standby mode.
• Press the Power button
The display shows current humidity and then change to show mist output
level 2 after 15 seconds. 1 Minute later, it turns back to show current humidity
again and repeats circularly.
• Touch the MAX/MIN button
output speeds. The corresponding digit will appear on the display. 1 – low,
2 – medium, and 3 – high. When current humidity shows on the display, touch
once to check the current mist output level, and twice to select another
mist output level.
MOIST C · HU-430CWA
, and the humidifier starts in mist output level 2.
, you can choose between 3 levels of mist
11
EN