Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
PRACTICAL APPLICATIONS
WARNING:
* To avoid personal injury, never remove or place a workpiece on the table while the tool
is being operated.
* Never place your limbs inside of the line next to warning sign while the tool is being
operated. This may cause hazardous conditions (see Fig. 22).
1. Switch operation
Hole
Fig. 23
WARNING:
2. Using the Vise Assembly (Standard accessory)
Screw holder
6mm wing
bolt (B)
Fence
Vise shaft
6mm wing bolt (A)
Fig. 24
WARNING:
CAUTION:
18
Warning Sign
Line
Pull the trigger to turn on the switch, release it to shut it off.
After releasing the trigger, make sure the trigger has gone all the
Trigger switch
way back and the switch is turned off.
This will ensure that the power tool cannot be turned on accidentally or by someone
(especially a child) who is not qualified to use the power tool.
To prevent unauthorized operation of this tool, insert a padlock through the hole in
the switch trigger.
(1) The vise assembly can be mounted on either the left fence
{Fence (B)} or the right fence {Fence (A)} by loosening the 6mm
wing bolt (A).
Knob
(2) The screw holder can be raised or lowered according to the
height of the workpiece by loosening the 6mm wing bolt (B).
Vise plate
After the adjustment, firmly tighten the 6mm wing bolt (B) and
fix the screw holder.
(3) Turn the upper knob and securely fix the workpiece in position
(Fig. 24).
Workpiece
Always firmly clamp or vise to secure the workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily harm.
Always confirm that the motor head (see Fig. 1) does not contact the vise assembly when it is
lowered for cutting. If there is any danger that it may do so, loosen the 6 mm wing bolt (B) and
move the vise assembly to a position where it will not contact the saw blade.
Warning Sign
Fig. 22
Line
Publicité
Table des Matières
