Pioneer PRS-A700 Mode D'emploi page 13

Specifications
Power source .......................................................................................................... 14.4 V DC (10.8 — 15.1 V allowable)
Grounding system .......................................................................................................................................... Negative type
Current consumption ........................................................................................................ 28 A (at continuous power, 4 Ω)
Average current drawn* ........................................................................................................ 9.7 A (4 Ω for four channels)
Fuse ........................................................................................................................................................................ 20 A × 2
Dimensions ...................................................................................................................... 300 (W) × 63 (H) × 330 (D) mm
Weight .................................................................................................................... 5.8 kg (Leads for wiring not included)
Maximum power output .................................................................................................................. 100 W × 4 / 300 W × 2
Continuous power output .............................................................. 50 W × 4 (at 14.4 V, 4 Ω, 20 — 20 kHz 0.08% THD)
Continuous power output (DIN power) .................................................. 70 W × 4 / 210 W × 2 (DIN45324, +B=14.4 V)
Load impedance .......................................................................................................................... 4 Ω (2 — 8 Ω allowable)
Frequency response ........................................................................................................ 10 Hz — 80 kHz (+0 dB, –1 dB)
Signal-to-noise ratio .................................................................................................................... 108 dB (IEC-A network)
Distortion ........................................................................................................................................ 0.003% (10 W, 1 kHz)
Separation .................................................................................................................................. 70 dB (100 Hz — 10 kHz)
Slew rate.............................................................................................................................................................. 40 V/µ sec.
Damping factor ................................................................................................................................................................ 50
Low pass filter ................................................................................................................ Cut off frequency: 40 — 120 Hz
High pass filter ................................................................................................................ Cut off frequency: 40 — 120 Hz
Gain control .............................................................................................................................................. 200 mV — 6.5 V
Maximum input level / impedance ...................................................................................................... RCA: 6.5 V / 22 kΩ
Note:
• Specifications and the design are subject to possible modification without notice
due to improvements.
*Average current drawn
• The average current drawn is nearly the maximum current drawn by this unit
when an audio signal is input. Use this value when working out total current
drawn by multiple power amplifiers.
All manuals and user guides at all-guides.com
15.2 A (4 Ω for two channels)
150 W × 2 (at 14.4 V, 4 Ω, 20 — 20 kHz 0.8% THD)
75 W × 4 (at 14.4 V, 2 Ω, 20 — 20 kHz 0.8% THD)
(Bridge connection: 4 — 8 Ω allowable)
Cut off slope: –12 dB/oct
Cut off slope: –12 dB/oct
12