Publicité
Les langues disponibles
Les langues disponibles
EN
Warning!
Do not place your hands into the chute when loading. This is a very UNSAFE method and could result in injury to your hands.
Do not reach or step across the rail while the Wood Chipper is running. This is a very UNSAFE method which could cause
personal injury, even death.
When Blocked
If the Roller stops while chipping woods or branches, the engine should be stopped, and take out the woods which stuck the
roller, and then restart the engine, and chip again.
Maintenance
Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this manual
and the engine manufacturer's user manual for maintenance procedures.
Warning!
Before performing any maintenance procedure or inspection, stop the engine, wait five minutes to allow all parts to cool.
Disconnect the spark plug wire, keeping it away from the spark plug. Disconnect the Battery Terminals (Electric start only).
Procedure
Check engine oil level
Check general equipment
condition
Check wedge for sharpness
Check belts
Check tire pressure
Clean engine exterior and cooling
Change Engine Oil
Replace air filter
Replace spark plug
Lubrication
Notice!
All Bearings of your Chipper are sealed units and should have sufficient lubricant to last the life of your machine with normal
use.
Troubleshooting table
Most problems are easy to fix. Consult the Troubleshooting Table below for common problems and their solutions. If you
continue to experience problems, contact the dealers in your area.
Greasing the rack and Pinion
Notice!
All the rack and pinion should be greased before every use.
Warning!
Before performing any maintenance procedure or inspection, stop the engine, wait five minutes to allow all parts to cool.
Disconnect the spark plug wire, keeping it away from the spark plug.
6
Before Each Use
Every 3 hours
●
●
●
●
First time/5 h
WWW.NikolaouTOOLS.gr
Every 25 hours
Every 100 hours
●
●
●
●
●
Publicité
