Frigidaire CARE4044MW Manuel D'installation page 18

REVERSING DOOR
5 Install four long screws securing hinge to door
assembly in the new location, take note to place each
hinge in correct orientation. (Figure below)
IMPORTANT
The plate with the stamped "D" is mounted to the door.
The "D" must be visible after the hinge is remounted
and the spine of the hinge should be oriented toward
the front side of the door for correct operation.
DOOR EDGE
SCREWS (x 4)
"D" STAMPED ON DOOR SIDE
OF HINGE INTERIOR
6 Install four long screws into holes that had secured
the hinges. (Figure above)
7 Remove striker and discard. (Figure below)
8 Remove square plug opposite striker. (Figure above)
If plug is damaged during removal, discard and install
new plug (included in literature bag) into hole striker
was just removed from.
18
9 Install new striker (included in literature bag) into hole
square plug was previously installed in. (Figure below)
10 Grasping fi rmly the top of the door, position the door
near the door opening and align the top hinge hole
to the top hole in the front panel door opening. Once
the fi rst short screw is started, attach the second
DOOR HINGE
short screw to the lower hinge. Once both screws
SCREWS (x 4)
are tightened, install the remaining two short screws.
(Figure below)
11 Install four plugs into the front panel door opening
where hinges were originally installed. (Figure above)
12 Close the door and test operation of hinge, strike and
latch.
HOLE PLUGS (x 4)
"D" STAMPED ON
DOOR SIDE OF
HINGE INTERIOR