Westinghouse WSHPTC136 Manuel D'instructions page 10

USING THE HEATER
1. Press the main POWER switch (5) to the on-position I. The
indicator next to the
2. Press the ON/OFF button (8) on the control panel. The
indicator next to the
The heater will immediately start heating at the highest level
and the indicator lights next to high power
temperature
3. Select the heater power level by pressing the MODE button (9)
repeatedly until the indicator light turns on next to the desired
function:
Low – 750W
High – 1500W
Economy – The heater will adjust the power level to
maintain the set temperature.
4. To set the temperature, press the TEMPERATURE button (11)
repeatedly until the indicator light turns on next to the desired
setting:
– maximum temperature
– 22 degrees Celsius
– 26 degrees Celsius
The heater will stay on until the room has reached your set
temperature. Then the heater will turn on and off to maintain
the room at that level.
NOTE: The heater must be set to a temperature level that is at least
a few degrees higher than the room temperature for the heating
function to be activated. If the heater does not appear to be
working, increase the temperature until the heating function turns
on.
5. To set the timer to turn the heater off in 1, 2, 4 or 8 hours, press
the TIMER button (10) repeatedly until the indicator light turns
on next to the desired setting:
– 1 hour
– 2 hours
– 4 hours
– 8 hours
EN
10
HOW TO USE
symbol will light up red.
symbol will turn from red to orange.
will turn on.
and maximum