Publicité
Les langues disponibles
Les langues disponibles
Storing the appliance for extended periods
en
Clean the appliance as described earlier and allow to dry
thoroughly. Preferably store the appliance in its original box,
in a dry place away from high temperatures.
Legal notice
The humidifier is cUL-listed.
Subject to technical change. The instructions for use are
protected by copyright © PLASTON AG.
Accessories
Contact your local retailer or check our website
www.airoswiss.net for re-order information.
Customer Service
Customer Service (USA) 1-800-336-0326
www.airoswiss.net
Troubleshooting
Problem
Unit does not operate
No mist output
Weak mist output
Unit running intermittently
White dust around the humidifier
16
Technical data
Electrical voltage
Power consumption up to
Humidity output up to
Suitable for rooms up to
Dimensions (LxWxH)
Weight (empty)
Accessories
* when used with pre-heating to 176 °F (80 °C)
Possible cause
Power cable not plugged in
No water in the tank (Empty-light red)
Unit needs cleaning
DMC exhausted
DMC overfilled with granules
Water temperature too low
Mineral deposits on membrane
Demineralization cartridge exhausted
120 V / 60 Hz
45 W / (125W*)
3.5 gallons / 24 h*
650 sq ft / 60 m
10 x 11.4 x 13.7 in
25.4 x 29 x 34.7 cm
8.8 lbs / 4 kg
7531 Demineralization cartridge
Hydro Cell A200
EZCal A7417
EZCal Pro A100
What to do
Plug in power cable
Fill tank with water and wait 10 min.
Descale the water base using EZCal and EZCal Pro
Replace cartridge or granules
Take out 2 tablespoons of granules and throw
them away
Set mist output to maximum, after 15 min.
the humidifier will work properly again
Clean membrane using EZCal and EZCal Pro and brush
Replace demineralization cartridge or granules
Used granules must go in waste
2
Publicité
