Wolf 812309 Mode D'emploi page 3

waLL MOUnT
For use with Models ICBPW3048, ICBPW3648, ICBPW448, ICBPW4848, ICBPW5448,
ICBPW6048, ICBPW6648, ICBPW3078,
ICBPW3678, ICBPW478, ICBPW4878,
ICBPW5478, ICBPW6078, ICBPW6678,
ICBPL34, ICBPL46, ICBPL5
prepare the wall
20"
1¼" dia. hole
Pilot Hole
(centered between studs)
14 / "
11
16
REMOVE
SIDING
14 / "
5
8
From inside the wall:
1
Drill a PiLOT HOLE through the wall, centered between
waLL STUDS.
From outside - on the wall:
2
Measure and mark the 25" x 29½" rectangle. Cut and
remove only the siding inside this rectangle.
3
Measure and mark the 11" DiaMETEr HOLE and the 1¼"
DiaMETEr HOLE. Cut these holes all the way through the
wall.
inSTaLLaTiOn
3"
11" dia.
hole
25"
install the Ventilator
4
Remove 10 COVEr SCrEwS and lift off ventilator cover.
5
Feed the electric power cable (supplied with ventilator)
through the 1¼" DiaMETEr HOLE in wall.
6
Position ventilator on wall so its discharge collar fits into 11"
diameter hole.
7
Use 6 screws (provided) to attach ventilator to wall. DriLL
6 MOUnTing HOLES inside ventilator, as necessary.
8
Seal screw heads and edges of flashing sheet with a good
grade of roofing cement or other sealant.
9
Check for free movement of spring-loaded damper and
re-install ventilator cover.
10 Cover 10 Cover
Screws Screws
29½"
Flashing
Sheet
attach power cords to hood
10
The ventilator is prewired with 12 feet of H05VV-F
3G1 power cable. Run ventilator cable to range hood's
electrical wiring box.
11
Secure cable to range hood with a strain relief (included
in parts bag). Make wiring connections per instructions
provided with your Wolf range hood.
12
Install the separate power cord and strain relief (included
in parts bag) to the range hood. Refer to instructions
provided with your Wolf range hood.
13
Turn on power and check for proper operation of
ventilator.
MODEL 812309
Damper
Bird Screen
OUTSIDE - ROOF VIEW OUTSIDE - WALL VIEW
Page 3
Drill 6
Mounting
Holes