EUROM EK3001 Manuel D'utilisation page 10

19. Do not use a timer or a similar product to automatically switch on the heater. Always perform safety checks
before using the heater!
20. Close supervision is necessary when the product is used near children or incapacitated persons. Do not let
children use the appliance as a toy. This appliance is not suitable to be operated by children or persons who
have physical, sensory and/or mental limitations, or by persons who have no knowledge of, or experience
with, this appliance.
21. Keep the heater clean. Dust, dirt and/or a build up of deposits in the heater are a common cause of
overheating. Make sure these deposits are removed regularly.
22. Do not turn on the appliance if you have discovered damage to the appliance, cord or plug, if the appliance is
malfunctioning, if it has been dropped or if there are signs of any other defect. Return the complete product to
the vendor or to a certified electrician for inspection and/or repair. Always ask for original parts.
23. Do not use attachments and/or accessories that have not been recommended or supplied by the
manufacturer.
24. The appliance (incl. cord and plug) may only be opened and/or repaired by properly authorised and qualified
persons.
25. Only use this heater for its intended purpose and as described in this instruction manual.
Not abiding by instructions 23, 24 and 25 may lead to damage, fire and/or personal injuries. A failure to adhere to
these rules also immediately nullifies the guarantee and vendor, importer and/or manufacturer do not take
responsibility for any of the consequences!
Description
EUROM EK heaters are 'real space' heaters, with a powerful fan which disseminates a great deal of air.
Cold air is sucked in at the back, heated, and then blown out as hot air. Because a relatively large quantity of air
is sucked in and blown out, the air expelled by the heater does not feel particularly hot. As a great deal of air is
heated and blown out, however, the entire space (not just the air around the heater!) is gradually warmed up.
Control panel EK3001:
The EK3001 control panel consists of two dials:
* The mode selector dial with 4 positions is located on the left.
From top to bottom:
* The continuously adjustable thermostat dial is located on the right.
Location and Connection

Remove all packaging material and keep out of reach of children. After removing packaging, check the
appliance for damage or other signs that could indicate a fault/defect/malfunction. In case of doubt, do not
use the appliance, but contact your vendor for inspection or replacement.

Choose a suitable location for the heater, i.e. at least one metre away from any obstructions, walls or
inflammable materials (see also safety instructions). Always ensure that the heater has sufficient space at the
back to suck in air and at the front, to blow out hot air (1 metre).

Make sure the heater is always in an upright position on a solid, flat, horizontal and non-flammable surface.

Make sure the heater is switched off (switch to O position), then plug into a correctly functioning, properly
grounded 230V-50Hz socket.
- O or off
- fan only
- 1500W power (low)
- 3000W power (high)
10